Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories This is a chassis mount

This is a chassis mount version of the connector used on the QDP kit board

This inductive proximity sensor has a Normally Closed operating mode

Here are the detailed specs for this sensor:

These ergomonic buttons reduce instances of Carpal Tunnel Syndrome - especially for operators running hand-fed single stroke presses

Output Type NPN Open collector Output Mode Light-ON/Dark-ON selectable Residual voltage 1V max

Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories This is a chassis mountThe Standard Spring Probe is one of the oldest and most versatile sensors used for die protection. Its operation is simple: The spring is connected to a terminal that is wired to a die protection input. The whole assembly is contained in an insulated plastic block. When a piece part, the coil stock, or tooling contacts the spring, it provides an electrical path to earth ground, which is detected by the die protection control. The Standard Spring Probe